Some people said This body grahic is good. Thanks!

Of course I think that the machine's looking is most important.

This is the chassis of my machine.

It's just normally TA05...I think this is the standard specification of TA05.

Introduction of mechanism

Servo FutabaS9450

Receiver FutabaR603FF

Amp KO VFS-1

Installed the GT tuned motor

Add a shot key diode it made by STRAIGHT on the motor wireling.Of course I can not understand It's effects.

Using European connectors.

Motor condition is not bad. But Lap time is not good.. Why?

This is VFS-1

Cable to the motor misappropriates the earth cable of the server.

It is too fat and too hard...

There is Condenser that made by unknown.. Mere consolation

The heat sink that made of alminium on the Amp before.But It has gone somewhere when last practice.If you will find it.Please tell me!

The receiver Is R603FF by Futaba.

This is 2.4GHz propo! Without care about band No is Good. But hardlyever I could not controll my machine at the circuit with this propo.

Maybe wireling of antena is ause of no controll?

When install the R603FF receiver.Top of the receiver and centerplate of TA05 touched and can not install if don't set the exit of wiring for in.

TRF dumperset with midium springs.

Stabilizers are front:mid rear:soft.

Viscosity of dumper oil usually #300 or #400

Short reverse suspension arms and wheels that offset 0.

Sets Front oneway and center oneway.

But I have ever seen the effects of the center oneway. 

I have ever seen the effects of the wide pitch pulley too...

It is three of the following that I felt the effect.

1,The expensive propo

2,High trouque servo saver

3,DigitalServo